#HOMESEER FORUM INSTEON SERIAL#
#HOMESEER FORUM INSTEON UPDATE#
#HOMESEER FORUM INSTEON PASSWORD#

Useful if you if you suspect communcation issues with a specific device. Display Interface Links - Read and display the PLM internal links to the screen. Generate Support Log File - This will dump the detailed log information save in memory to a Insteon Error Report.log file.ДҐ. Note: RF devices will have to be reprogrammed manually by entering linking mode, deleting the old links and programming the device for homeseer.Д¤. Program and Replace/Swapped Interface - this will reprogram all the registered device with the new PLM address. There is also an Insteon Action so this function can be run from an event.ДЈ. Hardware Reset and Reprogram Interface - this will execute a reset of the PLM and then complete reprogram the address database.

#HOMESEER FORUM INSTEON UPDATE#

Update insteon Interface Address Database - this will check for a write missing Insteon IDs into the PLM.Дў. Save Changes on this Page Click this to save the configuration changes made to this page.ДЎ. To clean this up, visit the source device and delete the links associated with the unregistered addresses. The following are unregistered Insteon addresses found in the network If you have old, unused, or unknown Insteon IDs in the network they can cause unnecessary traffic as source device will try to send messages to these non-existent devices. This is a good option when you are troubleshooting a specific device and don't want all the polling log entries. Perform group clean-ups when transmitting group commands After a group message is sent from the plugin, individual message are sent to each member of the group to ensure they heard the group message.Дisable automatic polling Use this to completely disable device polling for any device that has a non zero polling value. Sort Device Links Specifies the sort used for the links on the device page either by number or by the type of link. Please use Detailed Logging when posting logs to the forum for help. Logging Level Specifies the level of detail the plugin sends to the HS log. No Response Timeout for devices Specifies the number of seconds the plugin will wait for a response from the destination before the plugin retransmits the message. Number of retries on communication failure Specifies the number of times the plugin will attempt to transmit a message to a destination. Lowing it may cause messages to not reach their destination. Insteon Hops Allowed Specifies the number of times an Insteon msg is repeated within the network.

#HOMESEER FORUM INSTEON PASSWORD#

The default user name is admin, and the default password is the Hub's Insteon ID in all capitals. Enter the username and password for the Hub only.

#HOMESEER FORUM INSTEON SERIAL#

Interface Port Enter COM1, COM2, etc if you are using a serial or usb PLM. Once you have the PLM and plugin installed and working, this document will help you understand the features and capabilities of the plugin. Please see the 'Getting started with the PLM Insteon Plugin & Homeseer' before referencing this document. Plugin Documentation and Supported Device List

Homeseer forum insteon